Independently tested. Proven in real buildings.

A 72-hour trial in a genuinely contaminated, occupied apartment block, not a chamber. Spore concentrations fell sharply across every classification present, including Stachybotrys, the species associated with significant water damage.

Product

750+ Wall Mount (no filter)

Technologies

PCO / O₃ / ODOGard®

Duration

72 hours

Test space

Apartment block corridor & rooms

Administered by

Live field trial

• Contamination was deliberately maintained throughout the trial rather than isolated.

A second 72-hour live trial in an occupied property, again under continuous real-world contamination. Cladosporium, the most abundant airborne genus in most buildings, fell by more than 98%.

Product

750+ Wall Mount (no filter)

Technologies

PCO / O₃ / ODOGard®

Duration

72 hours

Test space

Residential house

Administered by

Live field trial

MS2 is an established surrogate for influenza and SARS-CoV-2. The unit reduced the aerosolised virus by an average net log of 1.86 ± 0.38 within four hours, demonstrating capability against airborne bio-aerosols rather than surfaces alone.

Product

750+ Wall Mount (no filter)

Technologies

PCO / O₃ / ODOGard®

Duration

4 hours

Test space

9.1′ × 9.1′ × 7.0′ sealed chamber (759 ft³)

Administered by

Aerosol Research & Engineering Laboratories

• Conducted in compliance with FDA Good Laboratory Practices (GLP).

Measured in real time over five days across a working office, covering airborne and surface contamination as well as gas-phase pollutants.

“It is my considered observation that the 750+ Wall Mount does provide a significant reduction of the typical air and surface contaminants tested. ASHRAE provides guidance as to the use of supplemental air purification after increasing fresh air ventilation to a minimum of 6 air changes per hour and filtration to MERV 13. This study was performed without those improvements. It is my considered opinion that if this unit was used within the current ASHRAE guidelines an even greater efficacy could be expected.”

Product

750+ Wall Mount (no filter)

Technologies

PCO / BPI / ODOGard®

Duration

5 days, measured in real time

Test space

1,240 sq ft commercial space

Administered by

Advanced IAQ Solutions (IAQS)

• Ozone levels were 0 ppm throughout the duration of the test.

A deliberately hostile gas-phase environment: a sealed store of cleaning chemicals inside a school. Both TVOC and formaldehyde fell substantially over five days of real-time measurement.

“There was a significant reduction of TVOC and HCHO from the initial readings which would not have been expected to occur without the introduction of this combined technology.”

Product

750+ Wall Mount (no filter)

Technologies

PCO / O₃

Duration

5 days, measured in real time

Test space

3,500 ft³ storage room

Administered by

Advanced IAQ Solutions (IAQS)

• Ozone levels remained below TLV guidance and below the levels measured outdoors for the full test.

A small, heavily occupied, poorly ventilated cabin, one of the hardest environments to hold. Ozone remained below detectable levels throughout.

“It is my observation and considered opinion that the technology had a significant effect on stabilizing the indoor air environment as well as definitively reducing airborne contaminants as defined by the readings. No single technology alone would produce those results.”

Product

750+ Wall Mount

Technologies

PCO / O₃ / ODOGard®

Duration

5 days, measured in real time

Test space

220 sq ft school bus

Administered by

Advanced IAQ Solutions (IAQS)

A hospital ran a four-week real-world study across active ambulances. Enclosed, high-turnover and time-pressured, they are among the hardest environments to keep clean, and among the highest-consequence.

Product

750+ Wall Mount (Transit)

Technologies

PCO / O₃ / ODOGard®

Duration

4 weeks, weekly sampling

Test space

Ambulance interior

Administered by

Pace Labs (CLIA & GLP compliant)

• EMS personnel carry the highest occupational risk of acquiring infectious disease of any profession, and often cannot complete infection-control protocols between patients.

The in-duct unit running as an active solution alone, with no filtration assistance, isolating what the technology itself contributes.

“It is my considered observation that pureAir HVAC does provide a rapid and significant reduction of the typical contaminants tested. The levels achieved and maintained during this test were far below any known standard or established TLV. It is my considered opinion that this sustained condition would not be typical or possible without the continuous use of this product.”

Product

HVAC (active solution only, no filter)

Technologies

PCO / BPI

Duration

5 days, real-time measurement

Test space

Commercial office space

Administered by

Advanced IAQ Solutions (IAQS)

• Ozone levels remained below TLV guidance and below the levels measured outdoors.

The same environment with an ODOGard®-coated MERV 13 filter added. This is the configuration we specify by default, and the difference it makes is the clearest argument for treating active and passive technology as one system.

“It is my considered observation that HVAC in combination with an ODOGard coated filter does provide a rapid and significant reduction of the typical air and surface contaminants tested. In my considered opinion, the sustained condition would not be achievable without the continual use of the technology represented.”

Product

HVAC + treated filter (active + passive)

Technologies

PCO / BPI / ODOGard® MERV 13

Duration

5 days, real-time measurement

Test space

1,240 sq ft room

Administered by

Advanced IAQ Solutions (IAQS)

• Ozone levels were 0 ppm throughout the duration of the test.

Test samples showed 0.89 log lower infectivity of SARS-CoV-2 compared with control samples after four hours of exposure.

Product

HVAC (active solution only)

Technologies

PCO / BPI

Duration

4 hours

Test space

9 × 9 × 9 ft test chamber

Administered by

MRIGlobal

Test samples showed greater than 4.75 log lower infectivity of MRSA compared with control samples after six hours. The test also demonstrated that the technology did not raise chamber concentrations of H₂O₂ or O₃.

Product

HVAC (active solution only)

Technologies

PCO / 20% O₃

Duration

6 hours

Test space

Controlled test chamber

Administered by

Microchem

• All four configurations run for 6 hours in a controlled chamber at Microchem, with no filter fitted.
• Each configuration was run for the same duration under the same chamber conditions.

The most direct evidence we have that the inside of an air conditioning unit is itself a contamination source. Viable mould on the fan housing and coil surfaces was removed completely, whether the unit ran continuously or only on temperature demand.

“The use of the PTAC unit completely removed the viable mold spores found on the fan housing and coil surfaces of the AC units. These results were the same whether the unit was operated continuously or as to temperature demand. It would be my considered opinion that PTAC would serve as an effective deterrent to mold growth on and in an AC unit, and would also be expected to produce a sustained and improved overall indoor air quality within the serviced areas.”

Product

PTAC (active solution only, no filter)

Technologies

PCO

Duration

5 days, measured in real time

Test space

220 sq ft dorm rooms

Administered by

Advanced IAQ Solutions (IAQS)